Remembering the settings (memory backup), In internal memory (p. 44), P. 44 – Roland RP201 User Manual
Page 42
44
Various Settings
Normally, the settings of the various variations will revert to their
default values when the power is turned off. However, you can
specify that the various settings will be remembered even when the
power is turned off.
This function is called “Memory Backup.”
1.
Hold down the [Song] button and press the [Metronome]
button.
The display will indicate “Fnc” and you’ll be in Function mode.
fig.d-Fnc.eps
2.
Press and hold the [Others] button and use the [–] or [+]
button to select “buP.”
fig.d-buP.eps
3.
When you take your finger off the [Others] button, the
[
] button will blink.
4.
Press the [
] button.
The display will indicate “Sur,” and the [
] button and [
]
button will blink.
fig.d-Sur.eps
If you decide not to save the settings, press the [
] button.
5.
To save the settings, press the [
] button.
The “buP” message flashes in the display.
Never turn off the power while “buP” is blinking in the display.
When the memory backup has been completed, the display will
indicate “Fnc.”
fig.d-Fnc.eps
For details on the settings stored by the Memory Backup
operation, refer to “Parameters Stored in Memory Backup” (p.
6.
Press the [Song] or [Metronome] button to leave
Function mode.
The settings you’ve changed in Function mode can be restored to
their factory-set condition. This operation is called “Factory Reset.”
Execute this operation if you want the settings you’ve stored using
Memory Backup to be returned to their original state.
When you execute “Factory Reset,” all settings you’ve stored
up to that point will be cleared, and reset to their factory-set
condition.
Executing this operation will not erase the songs from internal
memory. If you want to erase all songs from the RP201‘s
internal memory, refer to “Deleting All Songs” (p. 33).
1.
Hold down the [Song] button and press the [Metronome]
button.
The display will indicate “Fnc” and you’ll be in Function mode.
2.
Press and hold the [Others] button and use the [–] or [+]
button to select “Fct.”
fig.d-Fct.eps
3.
When you take your finger off the [Others] button, the
[
] button will blink.
4.
Press the [
] button.
The display will indicate “Sur,” and the [
] button and [
]
button will blink.
fig.d-Sur.eps
If you decide not to execute the Factory Reset, press the [
]
button.
5.
To execute the Factory Reset, press the [
] button.
The “Fct” message flashes in the display.
Never turn off the power while “Fct” is blinking in the display.
When the Factory Reset has been completed, the following display
will appear.
fig.d-End.eps
6.
Turn the [Volume] knob all the way toward the left to
minimize the volume.
7.
Switch the power off, then back on.
Remembering the Settings
(Memory Backup)
Restoring the Settings to the Factory
Condition (Factory Reset)
RP-201_e.book 44 ページ ２００９年１１月２０日 金曜日 午後２時３分