Programming guide, 70 mid – RayTek 54301 User Manual
Page 78

Programming Guide
There are eight entries possible for emissivity setting (1) and a related
set point (threshold) (2). To be able to write or read these values, use
the following commands:
EP=2
set pointer for table entry, e.g. to line 2 (3)
RV=0.600
set the emissivity value for line 2 to 0.600 (4)
SV=220.0
set the set point (threshold) for line 2 to 220.0 (5)
1
2
3
4
5
Figure 46: Table for Emissivity and Set Points
To activate these emissivity settings, you need to have the 3 external
inputs (FTC) connected. According to the digital combination on the
FTC wires, one of the table entries will be activated, see section 5.4.2
Emissivity Setting via Digital Selection
70
MID