Installation, Mid 17 – RayTek 54301 User Manual
Page 25

Installation
Preinstalled cable
to sensor head
Output signal and
power connector block
Cable that has to be
installed by the user
Figure 6: Connecting of Cables to the Electronic Box
5. Put the following on the cable (as shown in the figure above):
the cap (1), the plastic compression fitting (2), the rubber
washer (3) and one of the metal washers (4).
6. Spread the cable shield (5) and then slip the second metal
washer (4) on the cable. Note that the shield must make good
contact to both metal washers.
7. Slip the wires (6) into the electronic box far enough to
connect to the power and output terminals.
8. Screw the cap (1) into the electronics box. Tighten snuggly.
Do not over tighten.
9. Connect the wires (6) to the power and output terminals on
the printed circuit board.
MID
17