Roland VP-770 - Manual (Page 83)

83
This section explains the functions the diff erent registration parameters have, as well as the composition of
these parameters. For details on how to make settings, refer to “Editing a Registration” (p. 82).
REGISTRATION EDIT
These settings apply to the entire registration.
Parameter Value Description
Split ON, OFF Turns on the Split function, which divides the keyboard into separate zones
for the Vocal Designer and Ensemble parts.
Split Point 36 (C2)–84 (C6) Specifi es the key at which the keyboard is to be divided into separate zones
for the Vocal Designer and Ensemble parts.
Hold Freeze Part OFF, VOC, ENS The specifi ed part will not receive note-on messages when the Hold pedal
is pressed.
Ambience Type OFF Turns the ambience off .
HALL1 The reverberation of a church.
HALL2 The reverberation of a large hall.
STUDIO The reverberation of a studio.
Ambience Depth 0–127 Adjusts the depth of ambience.
Direct Mic Level 0–127 Specifi es the direct microphone volume (the audio signal selected by the
Input Source (p. 86) setting).
Direct Mic Amb Send 0–127 Specifi es the level of the signal that is sent from the direct microphone (the
audio signal selected by the Input Source (p. 86) setting) to Ambience.
REGIST CONTROL
Here you can make controller settings for the registration.
In the REGISTRATION EDIT screen, you can press the [F1] (CONTROL) button to access the REGIST
CONTROL (Registration Control setting) screen.
REGIST KEYBOARD
Parameter Value Description
Aft Assign Specifi es the aftertouch eff ect.
OFF Off
MOD Applies modulation.
DYN1 Changes the volume. Transmits MIDI message CC#2 (breath control) to the
sound generator section. This is the same operation as Voice Expression
(p. 66), and will operate only in the positive (+) direction to increase the
volume.
DYN2 Changes the volume. Transmits MIDI message CC#4 (foot control) to the
sound generator section. For STRINGS and BRASS sounds, this allows the
volume to be controlled in the ± directions (it will not go to zero). For other
sounds, the volume can be controlled only in the “+” direction.
FILTER Changes the tone.
WAH Applies a wah eff ect to sounds that support Wah.
BEND-DOWN Lowers the pitch.
BEND-UP Raises the pitch.
Aft Part Specifi es the part(s) that will be controlled by aftertouch.
VOC/ENS Vocal Designer part and Ensemble Part.
VOC Vocal Designer part only.
ENS Ensemble part only.
OFF Off
✍
Registration Parameters