Roland VP-770 - Manual (Page 65)

65
Use the cursor buttons and the value dial to change the value.
Parameter Value Description
Source REGIST, SYSTEM The assignments for the aftertouch can be stored individually in each
registration. When you select a diff erent registration, this setting specifi es
whether the aftertouch will be given the assignments stored in the
registration (REGIST), or the assignments stored in the system settings for
the entire VP-770 (SYSTEM).
Aft Assign Specifi es the aftertouch eff ect.
OFF Off
MOD Applies modulation.
DYN1 Changes the volume. Transmits MIDI message CC#2 (breath control) to the
sound generator section. This is the same operation as Voice Expression
(p. 66), and will operate only in the positive (+) direction to increase the
volume.
DYN2 Changes the volume. Transmits MIDI message CC#4 (foot control) to the
sound generator section. For STRINGS and BRASS sounds, this allows the
volume to be controlled in the ± directions (it will not go to zero). For other
sounds, the volume can be controlled only in the “+” direction.
FILTER Changes the tone..
WAH Applies a wah eff ect to sounds that support Wah.
BEND-DOWN Lowers the pitch.
BEND-UP Raises the pitch.
Aft Part Specifi es the part(s) that will be controlled by aftertouch.
VOC/ENS Vocal Designer part and Ensemble Part.
VOC Vocal Designer part only.
ENS Ensemble part only.
OFF Off
If you want to save your settings, press the [F2] (WRITE or SYS WRITE)
button.
For details on saving your settings, refer to “Saving a Registration” (p. 81) or “Saving the System Settings”
(p. 96).
When you’ve fi nished making settings, press the [EXIT] button.
To adjust the aftertouch sensitivity, use the system setting Aft Sens (p. 99).
2.
3.
4.
✍