Roland PCR-1 - Manual (Page 36)

36
Getting Connected and Installing Drivers (Macintosh)
11
Exit OMS Setup .
From the File menu, choose [Exit] . If the AppleTalk confirmation dialog box
appears, click [OK] to close the dialog box.
FreeMIDI settings
1
Use the USB cable to connect the PCR-1 to your computer .
2
From the CD-ROM, drag the Driver E (Mac OS 9) - FreeMIDI Setting folder
into the FreeMIDI Applications folder on the hard disk of your Macintosh
to copy it there.
3
Open the FreeMIDI Applications folder from the location into which you
installed FreeMIDI , and double-click the FreeMIDI Setup icon to start it up.
4
The first time you start up, use the following procedure.
1. A dialog box saying “Welcome to FreeMIDI!” will appear.
Click [Continue] .
2. The FreeMIDI Preferences dialog box will appear.
Click [Cancel] .
3. The About Quick Setup dialog box will appear.
Click [Cancel] .
This completes installation of the driver.
Next, make MIDI device settings in your sequencer or other software.
For details on how to make these settings, refer to the owner’s manual for your software.
For details on the PCR-1’s input / output devices, refer to Input / output devices (p. 44).
If you are using the PCR-1
in conjunction with other
MIDI devices, make
settings as described in
Readme_E.htm
located in
the Driver E (Mac OS 9)
folder of the CD-ROM.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after connecting the USB
cable is required before the
unit will operate normally.
When “OMS is installed
on this computer...”
appears, click [FreeMIDI].
PCR-1_e1.book 36 ページ ２００３年１１月２０日 木曜日 午後３時２２分