Roland PCR-1 - Manual (Page 15)

15
Getting Connected and Installing Drivers (Windows)
5
Click [OK] to close the System Properties dialog box.
6
Exit all currently running software (applications).
Also close any open windows. If you are using virus checking or similar
software, be sure to exit it as well.
7
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive of your computer.
8
Click the Windows start button. From the menu that appears, select
“Run...”
The “Run...” dialog box will appear.
fig.2-3_30
9
Specify the name of the file you want
to execute.
Enter the following into the “Open”
field, and click [OK] .
(drive name) : \Driver\USB_XP2K\SETUPINF.EXE
The SetupInf dialog box will appear.
You are now ready to install the driver.
* In the explanatory example shown here, the drive name is given as “D:” . The drive
name “D:” may be different for your system. Specify the drive name of your CD-
ROM drive.
10
Use the USB cable to connect the PCR-1 to your computer .
Near the task bar, your computer will indicate “Found New Hardware” .
Please wait.
11
The Found New Hardware Wizard will appear.
Select “Install from a list or specific location (Advanced)” , and click
[Next] .
If the screen indicates
“Windows can perform
the same action each
time you insert a disk or
connect a device with
this kind of file” , click
[Cancel] .
To check the drive name
Click the Start button, and
choose My Computer from
the menu that appears. In
the window that appears,
check the drive name of
the CD-ROM drive into
which you inserted the
CD-ROM in step 7.
The drive name is the (D:)
or (E:) displayed by the
CD-ROM drive
.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after connecting the USB
cable is required before the
unit will operate normally.
PCR-1_e1.book 15 ページ ２００３年１１月２０日 木曜日 午後３時２２分