Renesas Emulator System SH7362 - Manual (Page 19)

11
When the circuit is connected as shown in figure 1.6, the switches of the emulator are set as SW2
= 1 and SW3 = 1. For details, refer to section 3.8, Setting the DIP Switches, in the SuperH
TM
Family E10A-USB Emulator User’s Manual.
1
TCK
TMS
RESET
TDI
TDO
TRST
ASEBRK
/ BRKACK
GND
GND
GND
GND
(GND)
2
3
4
5
6
7
8
9
11
10
12
13
14
TCK
TMS
TDO
TDI
TRST
ASEBRK/BRKACK
N.C.
UVCC
H-UDI port connector
(14-pin type)
All pulled-up at 4.7 k Ω or more
1 k
Ω
User system
RESETP
MPMD
RESETA
Reset signal
Power-on reset signal
*2
*1
VccQ_SR
SH7362
VccQ_SR = 2.85-V/1.8-V I/O power supply
VccQ_MFI = 2.85-V/1.8-V I/O power supply
VccQ = 2.85-V I/O power supply
VccQ_SR VccQ_SR VccQ_SR VccQ_SR VccQ_SR
Level-shift
circuit
*3
Figure 1.6 Recommended Circuit for Connection between the H-UDI Port Connector and
MPU when the Emulator is in Use (14-Pin Type)
Notes: 1. Do not use /RESETP in the emulator after the user system has been activated.
When reset signals are used for debugging, use /RESETA.
2. Fix /RESETA as high level when it is not used.
3. When the voltage level of VccQ_SR (power supply for H-UDI and AUD) is 2.85 V
and that of VccQ_MFI (power supply for /RESETA) is 1.8 V, a level-shift circuit is
required as shown in the figure.