Raymarine autopilot User Manual
Raymarine GPS receiver
Table of contents
Document Outline
- ST6001+ Autopilot Control Unit
- Part 1: Using the ST6001+
- Chapter 1: Introduction
- Chapter 2: Basic Operation
- 2.1 Using the control unit
- 2.2 Using Auto mode
- 2.3 Adjusting display/keypad lighting
- Chapter 3: Advanced Operation
- 3.1 Using Track mode
- 3.2 Using Wind Vane mode – sail boats
- 3.3 Adjusting the rudder gain
- 3.4 Displaying data pages
- Chapter 4: Fault Finding & Maintenance
- Part 2: Installing the ST6001+
- Chapter 5: Installing the ST6001+
- Chapter 6: Commissioning the Autopilot
- Chapter 7: Adjusting Autopilot Settings
- 7.1 Calibration basics
- 7.2 Display Calibration
- 7.3 User Calibration
- 7.4 Seatrial Calibration
- 7.5 Dealer Calibration
- Accessing Dealer Calibration
- Dealer Calibration screens and settings
- SeaTrial Calibration lock
- Vessel type
- Drive type
- Align rudder
- Rudder limit
- Rudder gain
- Counter rudder
- Rudder damping
- AutoTrim
- Response level
- Turn rate limit
- Off course warning angle
- AutoRelease (I/O drives only)
- AutoTack angle
- Gybe inhibit
- Wind type
- WindTrim (wind response)
- Cruise speed
- AutoAdapt
- Latitude
- Magnetic variation
- Autopilot reset
- Dealer Calibration defaults: Types 150/150G & 400/400G
- Dealer Calibration options: Types 150/150G & 400/400G
- Appendix: Using the ST6001+ With Non-150/400 Autopilots
- Specifications
- Glossary
- Index