Data pages 1-7 – Raymarine autopilot User Manual
Page 94
Chapter 7: Adjusting Autopilot Settings
81
7
Adjusti
Data pages 1-7
The next 7 screens allow you to modify the settings for the data pages.
These define the SeaTalk/NMEA data pages that will be available
during normal operation (see page 29). Each data page setup screen
initially shows the title DATA PAGE and the page number. After 1
second, the text changes to the title of the data currently set for that
page.
The default settings are:
To change the data displayed on a data page:
•
Press disp to move to the appropriate data page setup screen.
•
Use the -1 and +1 keys to scroll forwards or backwards through
the available data pages (see following table).
•
Then press disp to move to the next data page you want to
change, or press and hold standby for 2 seconds to save changes.
Data page
Default setting
1
XTE (Cross Track Error)
2
BTW* (Bearing to Waypoint)
3
DTW* (Distance to Waypoint)
4
RESPONSE
5 -7
NOT USED (These pages are not displayed when you scroll
through the data pages during normal operation)
*Note: It is good practice to keep the BTW and DTW pages for display. If the
autopilot receives a man overboard (MOB) message, these data pages will
show the bearing and distance to the MOB location.
Available data pages
Displayed as
Speed Knots
SPEED KTS
Log
LOG XXXX.X
Trip
TRIP XXX.X
Average Speed, Knots
AV. SPD KTS
Wind Direction
e.g. WIND PORT
Wind Speed
WIND KTS
Depth Metres*
DEPTH M
Depth Feet*
DEPTH FT
Depth Fathoms*
DEPTH FA