Runco CINEMAWALL XP-OPAL65 - Manual (Page 59)

Operation
CinemaWall Installation/Operation Manual 45
PRE
L
IMINAR
Y
PORTRAIT SETUP: You can create a video wall consisting of three (3x1) CinemaWall
displays in “portrait” mode and display an enlarged image across all of them.
To do this, select PORTRAIT SETUP from the SET UP menu and press the ACTION ( )
button. Then, configure each display in the video wall as follows:
• PORTRAIT SETUP: Select PORTRAIT SETUP from the PORTRAIT SETUP menu, the
set it to ON to activate portrait mode.
• SEAM HIDES VIDEO: Refer to SEAM HIDES VIDEO on page 42.
• VIEWING AREA: If you are displaying SD images with a 4:3 aspect ratio in portrait
mode, select VIEWING AREA from the PORTRAIT SETUP menu and set it to 4:3.
• LOCATION: Select LOCATION from the PORTRAIT SETUP menu to specify the
CinemaWall’s position in the video wall. This determines which segment of the enlarged
image this panel will display. Select 1 for the left portion of the image, 2 for the center
portion or 3 for the right portion.
• AI SYNCHRONIZATION: Refer to AI SYNCHRONIZATION on page 42.
SET UP TIMER: To program the CinemaWall to turn on and/or off at specific times each
day, select SET UP TIMER from the SET UP menu and press the ACTION (
) button.
• POWER ON FUNCTION/POWER ON TIME: To enable automatic, time-of-day
power on, set POWER ON FUNCTION to ON. Then, press to select POWER ON
TIME.
Press or to change the POWER ON TIME in one-minute increments. Press and
hold or to change the POWER ON TIME in 15-minute increments.
• POWER OFF FUNCTION/POWER OFF TIME: To enable automatic, time-of-day
shutdown, set POWER OFF FUNCTION to ON. Then, press to select POWER OFF
TIME.
Press or to change the POWER OFF TIME in one-minute increments. Press and
hold or to change the POWER OFF TIME in 15-minute increments.
PRESENT TIME SETUP: Refer to Setting the Day and Time on page 21.
In order to activate portrait mode, you must first set the MULTI-PIP
DISPLAY MODE to “-” (normal). Refer to DISPLAY MODE on
page 43.
You cannot use the SET UP TIMER if you enable the Weekly
Command Timer (refer to page 47).
1 2 3
Note
Note