7 using picture-in-picture (pip), Activating pip, Swapping the main and pip images – Runco CINEMAWALL XP-OPAL65 User Manual
Page 40: Using picture-in-picture (pip), Pre l iminar y, A b a, B a b
26
CinemaWall Installation/Operation Manual
PRE
L
IMINAR
Y
4.7
Using
Picture-In-Picture (PIP)
Use PIP to display an image from two sources at the same time in a variety of ways.
For more information on setting up PIP and how it works, refer to MULTI PIP SETUP on
page 43.
Activating PIP
To activate PIP, press the MULTI PIP (
) remote control button.
Swapping the Main and
PIP Images
Press SWAP (
) to replace the main image with the secondary sub-image and vice
versa.
LETTER-
BOX3
–
LETTERBOX2 scales
(zooms in on) a 2.35:1
image linearly (by the same
amount on all sides) to fill a
16:9 display, cropping the
image on all sides.
CINEMA
CINEMA
Select CINEMA to view
2.35:1 source material in its
native aspect ratio.
CINEMA masks the upper
and lower portions of the
screen to create a viewable
area with a 2.35:1 aspect
ratio.
The geometry of the active
image area is unchanged.
Table 4-1. Aspect Ratio Settings (continued)
Aspect Ratio Setting
(Note)
Input Image -> Displayed Image
Description
All Aspect
= ON
All Aspect
= OFF
Note: To make all of the aspect ratio selections listed here available to the viewer, set All Aspect in
the OPTIONS menu (described on page 51) to On.
➤
➤
A B
A
B
A
B
B A
B
A
B
A
[Picture out Picture]
Main picture
Sub picture
[Picture and Picture]
[Picture in Picture]
Main picture
Sub picture
Main picture
Sub picture