RuggedCom RUGGEDBACKBONE RX1510 - Manual (Page 27)

RuggedBackbone™ RX1510
Installation Guide
Chapter 3
Installation
Serial Console Port 21
Figure 45: Critical Alarm Relay Connector
Section 3.4
Serial Console Port
The serial console port on the front panel provides access to the boot-time control and configuration menu
interface, and a console interface to the ROX operating system.
The serial ports implement RS232 DCE on a RJ45 connector. Serial settings are: 57600 bps, 8 bits, No parity, 1
stop bit. See the illustration and table below for pin configuration and assignment.
Figure 46: RJ45 Serial Console Port
Table 2: RJ45 Serial Console Pinout
RJ45 Pin Signal Function
1 DSR/RI
2 RLSD
3 DTR
4 GND
5 RD
6 TD
7 CTS
8 RTS
NOTE
The RX1510 connects the DSR/RI, RLSD, and DTR pins internally and does not drive or require these
pins.
The RX1510 connects the CTS and RTS pins internally and does not drive or require these pins.