RuggedCom RUGGEDBACKBONE RX1510 - Manual (Page 17)

RuggedBackbone™ RX1510
Installation Guide
Chapter 2
RuggedBackbone™ Modules
RuggedAPE™ (Appplication Processing Engine) 11
Section 2.3.8
RuggedAPE™ (Appplication Processing Engine)
Figure 27: RuggedAPE™ Module
NOTE
For more information about the RuggedAPE module, including installation and setup instructions, refer
to the APE Installation and User Guide.
Section 2.4
Power Supply
The RX1510 may be equipped with one or two power modules. The use of two power modules is recommended
to provide redundancy and load balancing.
A single power module is capable of delivering a maximum of 42W, and accepts either AC or DC power at its
input.
Power modules may be ordered with a screw terminal block or with a pluggable terminal block. The screw
terminal block features a safety cover which must be removed to make wiring connections, and must be replaced
after wiring is complete.
Power modules may be ordered as separate components. Refer to the RX1510 data sheet for complete ordering
details.
P
M
I
O
Figure 28: Screw terminal block power module: terminal cover in place (HI module shown)
P
M
I
O
Figure 29: Screw terminal block power module: terminal cover removed (HI module shown)