Module status leds, Line modules (lm), Ethernet - copper – RuggedCom RUGGEDBACKBONE RX1510 User Manual
Page 13: 1 module status leds, 3 line modules (lm), 1 ethernet - copper, Modules, see, Section 2.3, “line modules (lm)
RuggedBackbone™ RX1510
Installation Guide
Chapter 2
RuggedBackbone™ Modules
Module Status LEDs
7
• Critical Alarm (Failsafe) Relay Interface:
Section 3.3, “Critical Alarm Wiring”
Section 2.2.1
Module Status LEDs
The front panel module status LEDs provide the following information:
Table 1: Module Status LED Indications
LED
Purpose
Description
LM 1 through 4
Indicates the line module status.
Green = OK
Orange = Warning alert
Red = Configuration error
Section 2.3
Line Modules (LM)
The RuggedBackbone™ RX1510 supports four line modules in slots LM1 through LM4. Several types of line
modules may be ordered, depending on the type, speed and number of Ethernet ports required.
The following illustrations show the typical port configurations and connectors available for RX1510 line modules.
For complete information on the available line modules, refer to the RuggedBackbone™ RX1510 data sheet.
NOTE
Only one T1/E1 module may be used per router.
Section 2.3.1
Ethernet - Copper
Figure 3: CG01: 2 × 10/100/1000TX RJ45
Figure 4: CG03: 2 x 8-Pin 10/100/1000TX M12
Figure 5: 6TX01: 6 × 10/100TX RJ45
Figure 6: 4TX03: 4 x 8-Pin 10/100TX M12