Ricoh 3030 User Manual
Page 28
Faxing
20
2
-Checking the transmission
settings
You can check the transmission set-
tings (e.g. destination and transmis-
sion mode) on the display.
A
Press the {Check Modes} key, and
then check the transmission set-
tings.
The following display appears.
Note
❒ Pressing
switches the desti-
nation list between fax number,
e-mail address, and IP-Fax number.
B
After checking the settings on the
display, press the {Check Modes} key.
The display before the {Check Modes}
key was pressed appears.
-Broadcasting sequence
If you dial several destinations for the
same document (broadcasting), the
documents are sent in the order in
which they were dialed. If the fax
document could not be transmitted,
the machine redials that destination
after the last destination specified for
broadcasting. For example, if you
specify four destinations, A through
D, for broadcasting, and if the lines to
destinations A and C are busy, the
machine dials the destinations in the
following order: A, B, C, D, A, and C.
See p.80 “Simultaneous Broadcast”,
Facsimile Reference
To check the transmission progress,
print the TX file list. See p.26 “Print-
ing a List of Files in Memory (Print TX
File List)”, Facsimile Reference
If the optional extra G3 interface unit
is installed, you can use the Simultaneous
Broadcast function to send faxes si-
multaneously on different phone lines.
-Memory Transmission
sequence
If you specify a second transmission
while broadcasting to several destina-
tions, faxes are transmitted alternate-
ly to each remaining destination in
the current and second broadcast.
For example, if you specify a broadcast
to destinations A and B, and then specify
a broadcast to destinations C and D
while transmission to destination A is in
progress, the machine sends the faxes in
the following order: A, C, B, and then D.
If the previous file and next file are both on
standby, these are also sent in the same order.
ZLBS040N
RussianC4-AE_Combine-F_FM.book Page 20 Friday, April 15, 2005 11:13 AM