Adjusting the display contrast (lcd contrast) – Roland JUNO-D User Manual
Page 16
16
Getting ready
Turning off the power
1.
Before you turn off the power, make sure of the following points.
• Are the volume controls of the JUNO-D and the other connected equipment
turned to the minimum position?
• Have you saved the sounds or other data you’ve created? (p. 48, p. 53, p. 59)
2.
Turn off the power for all connected audio devices.
3.
Turn off the JUNO-D’s power switch.
Adjusting the display contrast
(LCD CONTRAST)
The characters in the display may be difficult to view immediately after turning on
the power or after extended use; this may also be because of where and how the
display is situated. Follow the steps below to adjust the display’s contrast.
fig.q01-04
1.
Press [SYSTEM] so it is lit.
2.
Use PAGE/CURSOR [
]/[
] to select “LCD Contrast.”
fig.q01-05
3.
Use VALUE [-]/[+] to set the value (1–10).
2
3
1
The LCD CONTRAST
setting is saved
automatically, and is
retained even while the
power is off.
JUNO-D_e.book 16 ページ ２００４年６月１１日 金曜日 午後１時２１分