Roland SC-545EX - Manual (Page 9)

7
Be sure to install the shafts when
loading roll media.
Otherwise the roll may fall and cause injury.
Release the caster locks for the stand
before attempting to move.
Otherwise the
unit may tip
over and cause
injury.
Do not touch the control panel while
head cleaning or other cleaning is in
progress.
The print-head carriage may move and cause
injury.
To Ensure Safe Use
Use care to avoid pinching the fingers
when placing the unit on the stand.
Doing so may
result in injury.
Use the joining screws to secure the
unit to the stand.
Failure to do so
may result in
falling of the unit,
leading to injury.
Install in a level and stable location.
Failure to do so may result in the unit tipping
over, leading to injury.
Unpacking, and installation must be
carried out by four or more persons.
Otherwise the machine or the stand may fall,
resulting in injury.
Before switching on the power, be
sure to install the drain bottle.
Otherwise discharged fluid may leak from the
machine.
Do not place hands within the space
to the front of the unit while in opera-
tion.
Doing so may
result in injury.
Do not touch the tip of the blade with
your fingers.
Doing so may result in injury, and the cutting
performance of the blade will be impaired.
Do not touch the platen when the print
heater is operating.
Doing so may cause burns because the
platen is hot.
Do not touch the tip of the separating
knife with your
fingers.
Doing so may re-
sult in injury.
Load roll media at the proper position.
Otherwise the roll may fall, resulting in in-
jury.
Be sure to use the media with a width
of 500 mm (19-11/16 in.) or more.
Failure to do so may cause overheating of
the print heater, leading to fire.
Do not press the [SEL] key.
Doing so may cause malfunction of the print
heater, leading to fire.
When cleaning the unit, be sure to
wait approximately 30 minutes or
more after switching off the power
until the temperature of the platen
falls sufficiently.
Doing so may cause burns because the
platen is hot.