Roland SC-545EX - Manual (Page 33)

31 Chapter 1: Getting Started
1-5 Switching On the Power for the First Time
Filling Ink
Installing ink cartridges for the first time after purchase requires four unused SOL INK cleaning cartridges. This is also
the case when you are draining ink in preparation for transport, then reinstalling the ink cartridges.
1 Switch on the main power on the back of the
machine.
2 Press the [POWER] key on the operation panel.
3 Check the type of ink to install, then press the
[ENTER] key.
4 Follow the messages to make sure the drain
bottle is installed at the back of the machine.
5 Insert cleaning cartridges into the ink-cartridge
ports shown by flashing on the display.
Cleaning starts. The cartridges are inserted and
removed while the operation is in progress.
Follow the messages on the display to carry
out the procedure.
Cleaning may take some time.
6 When cleaning ends, the following message
appears. Follow the instructions given in the
message to remove the cleaning cartridges.
7 Empty the drain bottle and press the [ENTER]
key.
8 Before you insert the ink cartridges for each
color, gently shake the cartridges.
9 Firmly insert the ECO-SOL INK cartridges for
each of the colors as far as they will go.
Ink filling starts. When this screen appears, filling ink is
finished.
For more information about how to dispose of dis-
charged ink, see "5-5 Disposing of Discharged Ink."
SELECT INK TYPE
ECO-SOL LcLm
INSTALL
DRAIN BOTTLE
SET SOL CL - LIQUID
1 2 3 4 5 6 7 8 9 10 11 12
REMOVE SOL CL
1 2 3 4 5 6 7 8 9 10 11 12
SET SOL CRT.
1 2 3 4 5 6 7 8 9 10 11 12
EMPTY
DRAIN BOTTLE
SETUP SHEET
ROLL