Roland SC-545EX - Manual (Page 40)

38 Chapter 2: Basic Operation
2-1 Examples of Operations with This Machine
You can perform a wide variety of operations with this machine. For example, you can perform only printing, perform
only cutting, or perform printing and cutting, or even perform printing, then remove the media, laminate it, and then cut
it.
The results of operations such as printing only or cutting only differ depending on the settings used to send the data from
the raster image processor (RIP). For information on how to make the RIP settings, refer to the documentation for the RIP
you're using.
For detailed information about the different operations, refer to the following sections of this manual.
• Performing printing only ☞ "2-4 Printing"
• Performing cutting only ☞ "2-5 Cutting"
• Performing printing and cutting ☞ "2-6 Printing and Cutting"
• Removing the media after printing, then reloading it and performing cutting
☞ "2-7 Reloading the Media and Performing Cutting"
• Using the print heater ☞ "Chapter 3: Using the Print Heater"