3) select a midi channel, 4) part setting – Roland TD-12 User Manual
Page 65
65
Chapter 7. Sequencer (Recording/Editing)
Chapter 7
[REC]
(2) Set the Time Signature, the
Number of Measures, and the Tempo
1.
In the “PATTERN” screen, press [F3 (FUNC)] -
[F1 (SETUP)].
The “PATTERN SETUP” screen appears.
fig.06-PtnSetup_70
2.
Press [CURSOR] to select the parameter.
3.
Use [+/-] or [VALUE] to make settings.
Time Signature can be set on an empty pattern. You
cannot set 1/8 and 1/16–3/16.
If REC Mode (p. 66) is set to “Replace,” it is not necessary
to specify the Length. Recording will continue until you
press [STOP], and the number of measures recorded will
automatically become the “LENGTH” setting.
You can have a count sound (click) inserted before
recording begins by pressing [TEMPO] - [F1 (CLICK)] -
[F3 (COUNT)] and then setting Count In Rec (p. 63).
If you are recording from the pads,
disregard paragraphs (3) and (4) of this
section.
(3) Select a MIDI Channel
Be sure that the transmit channel on your keyboard
corresponds to the MIDI channel of the part you wish to
record.
Each part has it’s own MIDI channel. The factory preset
channels are as follows:
You can change the MIDI channel by pressing [SETUP] -
[F1 (MIDI)] - [F1 (MIDI CH)] (p. 72).
You can record the percussion part with pads by pressing
[SETUP] - [F1 (MIDI)] - [F2 (GLOBAL)] and then setting
Local Control to “ON (PERC)” (p. 73).
(4) Part Setting
Follow the procedures described in
(p. 56) to make settings of the parts.
Parameter
Value
Pattern Length
1–999
Time Signature
Numerator: 1–15
Denominator: 2, 4, 8, 16
Tempo
20–260
Part
MIDI Channel
Drum Kit part
CH10
Percussion part
CH11
Melody part
CH1
Bass part
CH2
Backing 1 part
CH3
Backing 2 part
CH4
TD-12_e.book 65 ページ 2005年2月18日 金曜日 午後6時39分