Identifying false echo returns, Side lobes – Raymarine hsb2 PLUS Series User Manual
Page 69
![background image](/manuals/196630/69/background.png)
Chapter 3: Standard Radar Operations
3-5
Id
enti
fyi
ng F
al
se E
cho
Re
tu
rn
s
Identifying False Echo Returns
Not all echoes are direct returns to the radar antenna. Occasionally signals
appear at positions where there is no actual target. These are called false
echoes, and may be caused by side lobes, ghost images, indirect echoes or
multiple echoes.
This section briefly describes the echo patterns that can be produced by false
echoes and the likely cause. It should be noted that the radar operator, through
observation, practice, and experience, can generally detect these conditions
very quickly. These effects can usually be minimized using the radar controls.
Side Lobes
A small part of the RF energy from each transmitted pulse is radiated outside
the single narrow beam. This produces side lobe patterns, shown in
Figure 3-3.
Side lobes have no effect on distant or small surface objects. However, the
echo from a large object at short range may produce an arc on the radar screen
similar to a range ring or a series of echoes forming a broken arc. Side-lobe
echoes normally occur at ranges below 3nm, and can be reduced by adjusting
the SEA control.
Figure 3-3:
Side Lobes
True echo
Side echoes
Main lobe
Antenna
Arc
Side lobe
Side lobe
D1638-2
81186_3.book Page 5 Thursday, August 22, 2002 8:23 AM