Raymarine hsb2 PLUS Series - Manual (Page 135)

Chapter 5: Standard Chart Operations 5-37
Tr
an
sf
errin
g
Wa
yp
oi
nt
s a
nd
R
out
es
➤ To receivethewaypointandroutelistsvia
hsb 2 , you must set-up the transfer on
both display units - one unit will send waypoints, the other will receive them.
CAUTION:
Receiving waypoints from another
hsb 2 instrument overwrites any
existing waypoint and route lists.
1. Display the waypoint list as previously described, then press the WAY-
POINT TRANSFER soft key.
2. Press the soft key SEND WPT LIST ON HSB or RECIEIVE WPTS FROM HSB. You
are prompted to confirm:
Press NO to cancel the operation, then ENTER if you wish to close the way-
point list.
Press YES to continue. The waypoint list is transmitted to/from the chart-
plotter from/to another instrument on
hsb 2 . While the data is being trans-
ferred the soft key changes to STOP SENDING WAYPOINTS; when the
transfer is complete the soft key is re-displayed.
WAYPOINT
TRANSFER
81186_3.book Page 37 Thursday, August 22, 2002 8:23 AM