beautypg.com

Making connections, Connecting the ac adaptor, Use this to secure the ac adaptor cord (p. 14) – Roland GW-8 User Manual

Page 14: Connect the included ac adaptor here (p. 14)

background image

14

Introduction

Non-Rewritable memory

Preset memory

Data in Preset memory cannot be rewritten. However, you can
call up settings from preset Performances into the temporary
area, modify them and then store the modified data in
rewritable memory.

USB memory

You can back up your settings to USB memory in the following
units of data. (p. 49)

• Sound/System

User Performances, Favorite Tones/Performances, system
settings

• Style

User Styles

• Song

User Songs

• All

Style and Song in addition to the Sound/System data
listed above

To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.

When connection cables with resistors are used, the volume
level of equipment connected to the input (EXT INPUT jack)
may be low. If this happens, use connection cables that do not
contain resistors.

1.

Make sure that the [POWER] switch is off.

2.

Move the VOLUME knob all the way to the left to minimize

the volume.

3.

Connect the included power cord to the included AC

adaptor.

The indicator will light when you plug the AC adaptor into
an AC outlet.

fig.ACadap.eps

Place the AC adaptor so the side with the indicator (see
illustration) faces upwards and the side with textual
information faces downwards.

Depending on your region, the included AC adaptor may be
a different type than the one shown above. If so, omit step 3
and proceed.

4.

Connect the AC adaptor to the DC IN jack on the GW-8’s

rear panel, and then plug the AC adaptor into an electrical

outlet.

To prevent the inadvertent disruption of power to your unit
(should the plug be pulled out accidentally), and to avoid
applying undue stress to the AC adaptor jack, anchor the
power cord using the cord hook, as shown in the illustration.
Even if the cord is fastened, strong tension applied to the cord
may cause it to be damaged or broken. Be careful not to pull
the cord accidentally, or to apply strong pressure to it.

Making Connections

Connecting the AC Adaptor

to an AC outlet

AC adaptor

Power cord

Indicator

GW-8_e.book 14 ページ 2008年4月1日 火曜日 午前11時44分