Renesas M38000TL2-FPD - Manual (Page 34)

( 32 / 54 )
Chapter 4. Usage
4.1 Turning On the Power Supply
(1) Checking the Connection of the System
Before turning the power ON, check the connection of the PC4701, emulation pod, converter board
and target system.
(2) Turning On the Power Supply
Power ON/OFF the target system and the PC4701 as simultaneously as possible.
CAUTION
Notes on Power Supply:
• The emulator's V
CC
pin is connected to the target system in order to monitor target
system voltage. For this reason, the emulator cannot supply power to the target
system. Therefore, provide the target system with a separate power supply from that
of the emulator.
• Keep target system power supply voltage within the MCU's specified range and
between +0.9 and 5.5 V.
• Do not change target system power supply voltage after power has been activated.