Renesas M38000TL2-FPD - Manual (Page 26)

( 24 / 54 )
(1) When Emulator MCU is an RSS or RLSS Chip
If the emulator MCU is an RSS or RLSS chip, use the 28DP-WS board as the probe direction
converter board to connect with the target system. When connecting, match the No. 1 pin of the 28DP-
WS, emulator MCU and target system. When using the 28DP-WS board, you can choose one of two
methods of connection that is matched to the direction of the emulator MCU on the target system.
Figure 3.5 shows each method of connection.
Figure 3.5 Connecting the M38000TL2-FPD and RSS/RLSS chip
Pin numbers in the diagram indicate the probe direction converter board's pin numbers that are
connected to the emulator MCU.
PCA7733 REV.B
28DP-WS
No. 1 pin
(printed)
Emulator MCU
RSS chip
No. 1 pin
Target system
No. 1 pin
Direction for connecting
target system
Direction for connecting
target system