RuggedCom RuggedRouter RX1000 - Manual (Page 30)

RuggedRouter  User Guide
End Backup Server, VPN Server, NFS, OSPF/RIP protocol and firewall) are
disabled by default.
Accessing The RuggedRouter  Command Prompt
From the Console Port
Attach a terminal (or PC running terminal emulation software) to the RS232 port on
the rear of the chassis. The terminal should be configured for 8 bits, no parity
operation at 38.4 Kbps. Hardware and software flow control must be disabled. Select
a terminal type of VT100.
Once the terminal is connected, pressing will prompt for the user to login as
and that user's password. Sign-in as either the rrsetup or root user. The router is
shipped with default passwords of “admin” for either of these accounts.
From SSH
Use an SSH agent running the version 2 protocol. SSH to either the rrsetup or root
accounts of the router at one of its IP addresses described above. The router is
shipped with default passwords of “admin” for either of these accounts.
The RuggedRouter Setup Shell
Signing-in as the rrsetup user will automatically enter the configuration shell shown
below. Quitting the shell (with cancel, or by entering escape) will cause the
connection to close.
Figure 1: RuggedRouter Setup Main Menu
The shell provides a number of configuration commands, described below.
Configuring Passwords
The Change Passwords command changes the rrsetup and root account passwords.
These passwords should be changed before installing the router on the network.
28 RuggedCom