RuggedCom RuggedRouter RX1000 - Manual (Page 130)

RuggedRouter  User Guide
The “Apply Configuration” button restarts the server to activate any configuration
changes that have been made, restarting VPN connections.
Figure 106: IPsec VPN Configuration After Connections Have Been Created
Server Configuration
Figure 107: Server Configuration
The Protocol Stack field configures whether route based or policy based VPNs are
used. Following the link will take the user to menu that requests a reconfirmation and
then changes the style of VPN.
The Network interfaces for IPsec table configures the association between ipsec
interfaces and the real interfaces upon which they become available.
If the Default field is selected, Openswan will use its current default (Default route
interface at the time of writing) to associate the named ipsec interface with.
If the Default route interface field is selected, Openswan will use the real interface
owning the default route to associate the named ipsec interface with.
If the Default field is selected, Openswan will use its current default (Default route
interface at the time of writing) to associate the named ipsec interface with.
If the Listed below.. field is selected, Openswan will establish the real to ipsec
interfaces listed.
128 RuggedCom