Renesas 32176 - Manual (Page 66)

32176 Group
Starter Kit User’s Manual M3A-2152
REJ10B0224-0310/Rev.3.10 Mar. 2008 Page 58 of 83
3. Reference Data
3.1 Jumper and Test Pin Lists
3.1.1 Jumpers
Table 3.1 Jumper List
Jumper No. Default Description
J1 Shorted between 1–4 Outputs a clock from X1 (surface mount-type oscillator module)
J2 Shorted between 1–2 Sets MOD1 to 0
J4 Shorted between 1–2
Controls MOD0 by EXTMOD0, unless control MOD0 by EXTMOD0
sets MOD0 to 0
J5 Shorted between 1–2 Uses the CAN0 terminating resistor mounted on-board
J6 Shorted between 1–2 Enables reprogramming the M32R/ECU’s internal flash
J7 Shorted between 1–2 Uses the CAN1 terminating resistor mounted on-board
J9 Shorted between 1–2 Connects P83/RXD0 to the extension connector (CON2)
J10 Shorted between 1–2 Connects P86/RXD1 to the extension connector (CON2)
J11 Shorted between 1–2 Connects P175/RXD2 to the extension connector (CON2)
J12 Shorted between 1–2 Connects P75/RXD3 to the extension connector (CON1)
J13 Shorted between 1–2 Connects P221 to the extension connector (CON1)
J14 Shorted between 1–2 Connects P77 to the extension connector (CON1)
H1 Shorted between 1–2 Power supply from VCCE (CN2)
H3 Shorted between 1–2 Uses the VR control (VOL0)
H4 Shorted between 1–2 Uses the VR control (VOL1)
H6 Shorted between 1–2 Power supply from AVCC
3.1.2 Test Pins
Table 3.2 List of Test Pins
Test Pin No. Signal Name Test Pin No. Signal Name
TX1 AVCC TX10 CANL0
TX2 GND TX11 CANH1
TX3 GND TX12 CTX1
TX4 VCCE TX13 CRX1
TX6 MOD0 TX14 FP
TX7 CANH0 TX15 CANL21
TX8 CTX0 TX16 TXD1
TX9 CRX0 TX18 VREF0