Ricoh Camera CX6 - Manual (Page 162)

0
9
Appendic
es
Care and Storage
Care
• Please note that if fingerprints, dirt, etc. get onto the lens, picture quality will
suffer.
• When dust or dirt does get on the lens, do not touch it directly with your
fingers, and either use a blower (available in stores) to blow it off, or a soft
cloth to gently dust it off. Special care should be taken for the lens barrel.
• After use at the beach or around chemicals, wipe it off particularly carefully.
• In the unlikely event that your camera fails to work properly, please consult
your Ricoh Repair Center.
• There are high voltage circuits in this camera. As this is dangerous, do not
dismantle this camera under any circumstances.
• Do not get volatile substances, such as thinner, benzene, or pesticides on
your camera. This may cause a change in quality, paint to peel, etc.
• As the surface of the picture display is easily scratched, do not rub hard
objects against it.
• Clean the surface of the picture display by wiping gently with a soft cloth
containing a small amount of display cleaner (that does not contain organic
solvents) sold in stores.
Use and Storage
• Please avoid using or storing your camera in the following kinds of places, as
this may damage the camera.
- In high heat and humidity, or where there is severe change in temperature
or humidity.
- Places with a lot of dust, dirt or sand.
- Places with severe vibration.
- Places where it is in direct contact with vinyl or rubber products or chemicals,
including mothballs or other insect repellent, for long periods of time.
- Places with strong magnetic fields (near a monitor, transformer, magnet, etc.).
• Store your camera in a dust-free camera bag, etc. to prevent dust or dirt from
getting on the camera. Also, avoid carrying the camera without a case (in
your pocket, etc.) to help to keep free from dust or fiber particles.
• Remove the battery if you are not going to use the camera for a long period
of time.
Precautions regarding care of your camera
1. Be sure to turn the power off.
2. Remove the batteries before caring for your camera.