Nortel Networks Nortel Secure Router 4134 - Manual (Page 7)

7
Introduction
This document provides information about the recommended method to
commission the Secure Router 4134. For a complete list of Command Line
Interface (CLI) commands that you use to monitor and configure the Secure
Router 4134, see Nortel Secure Router 4134 — Command Line Reference
(NN47263-507).
Prerequisites
• Hardware installation is complete.
• You must have a console cable to connect to the console port on the
rear panel of the router.
• You must have an Ethernet cable to connect to the management port on
the rear panel of the router.
• Be familiar with using the CLI and interpreting partial configuration
procedures. See Nortel Secure Router 4134 — Using the Command
Line Interface (NN47263-506).
Navigation
• "Secure Router 4134 commissioning" (page 9)
• "Commissioning configuration procedures" (page 13)
Nortel Secure Router 4134
Commissioning
NN47263-302 01.02 Standard
10.0 2 August 2007
Copyright © 2007, Nortel Networks
.