Nortel Networks Nortel Secure Router 4134 - Manual (Page 29)

Configuring the static default route 29
Configuring the host name
Configure a host name for the Secure Router 4134 to uniquely identify it.
Once assigned, the host name becomes the CLI prompt name.
ATTENTION
Changing the host name later (that is, post commissioning), and committing this
change, drops all Telnet and SSH connections. All active console sessions also
end.
Procedure steps
Step Action
1 To access configuration mode, enter:
configure terminal
2 To configure the host name for the Secure Router 4134, enter:
hostname
—End—
Table 6
Variable definitions
Variable Value
The name you want to assign to the Secure
Router 4134.
Configuring the static default route
Configure a static route to specify a preferred route to a destination. You
can identify the gateway, or next-hop, for a static route by specifying one
of the following:
• IP address of a directly connected interface
• name of a local interface such as ethernet0/0
Procedure steps
Step Action
1 To access configuration mode, enter:
configure terminal
2 To configure the gateway route, enter:
ip route
—End—
Nortel Secure Router 4134
Commissioning
NN47263-302 01.02 Standard
10.0 2 August 2007
Copyright © 2007, Nortel Networks
.