Nortel Networks Nortel Secure Router 4134 - Manual (Page 23)

Enabling the management LAN port 23
Figure 6
Management port on the rear panel of the Secure Router 4134
Prerequisites
• You must be connected to the Secure Router 4134 through the console
port. See
"Connecting a terminal for local access" (page 14) for
information about connecting a terminal to the console port.
• You must log in as a user with sufficient permissions to configure the
Secure Router 4134.
• You must have the IP address and netmask that you want to assign
to the management port.
The following procedure uses Ethernet port 0/0 (on the rear of the Secure
Router 4134) for the management port. You can also use port 0/1 or port
0/2 on the front panel of the Secure Router 4134 for management purposes.
Ethernet port 0/0 is a 10/100 Base-T port. Ethernet ports 0/1 and 0/2 are
10/100/1000 Base-T ports.
Procedure steps
Step Action
1 To access configuration mode, enter:
Nortel Secure Router 4134
Commissioning
NN47263-302 01.02 Standard
10.0 2 August 2007
Copyright © 2007, Nortel Networks
.