NEC MC2400 - Manual (Page 93)

Upgrading Your System 4-11
Assembling the Pentium II Processor
9. Position the processor so that the heat sink faces the center of the system
board. Slide the processor into the retention module. Ensure that the
alignment notch in the S.E.C. cartridge fits over the plug in Slot 1. Push
down firmly, with even pressure on both sides of the top, until the S.E.C.
cartridge is seated.
10. To lock in the processor, push the latches outward until they click into place
in the retention module (see figure, below). The latches must be secured for
proper electrical connection of the processor.
Locking in the Processor
11. After you have installed a new processor, you must run the BIOS Setup
Utility (F2) to configure its speed. Refer to Chapter 3, “Configuring Your
System.”
12. Replace the left side panel, plug in the system power cords, and power up
the system.