NEC MC2400 User Manual
Page 72
3-22 Configuring Your System
To change device configuration parameters, perform the following steps:
1. At the SCSI Configuration Utility Main Menu, select the adapter which
connects to the SCSI device you are reconfiguring. The first adapter listed
controls the operation of the hard disk drives; the second adapter controls
any SCSI removable media devices installed in your system. Press ENTER.
2. Select “Device Selections” and press ENTER. The Devices 0 to 7 screen
displays.
3. Select the SCSI device you are reconfiguring and press ENTER. If you are
configuring SCSI Hard Disk Drives, refer to the SYM53C875 Adapter 1
Table below; if you are configuring SCSI Removable Media Devices, refer
to the SYM53C875 Adapter 2 Table below for recommended settings.
SYM53C875 Adapter 1 – SCSI Hard Disk Drives
Description
Recommended Setting or
Display Only
Your Configuration
Device Selections
Press ENTER for menu.
Select device and press
ENTER.
Dev0
Dev1
Dev2
Dev3
Sync Rate
40
Width (bits)
16
Disconnect
On
Read/Write I/O timeout
(secs)
10
Scan for device at boot time
Yes
Scan for SCSI LUNS
No
Queue Tags
On