NEC MC2400 User Manual

Page 89

Upgrading Your System 4-7

Replacing the Real-Time Clock Battery

1. Power off the system and remove the left side panel as described earlier in

this chapter.

2. Insert the tip of a small flat-bladed screwdriver, or equivalent, under the

plastic tab on the San-in plastic retainer (A in figure).

3. Gently push down on the screwdriver to lift the battery (B).

4. Remove the battery from its socket (C).

5. Dispose of the battery according to local ordinance.

6. Remove the new lithium battery from its package, and, being careful to

observe the correct polarity, insert it in the battery socket.

7. Reinstall the plastic retainer on the lithium battery socket.

8. Replace the side panel, plug in the system power cord, and turn on the

system.

9. Run the BIOS Setup to restore the configuration settings to the real-time

clock.

OM06416