NEC MC2400 - Manual (Page 161)

System Setup Utility B-11
Recommended Resource Settings
The following table shows the recommended RCA system board settings for a
sample system and provides a place for you to record any changes you make to
the settings.
SYSTEM GROUP NORMAL SETTING YOUR CONFIGURATION
System Identification and Version
Information
SSU Configuration File Version Display Only
MP Spec. Version V 1.4
Processor Speed Setting 3.5 X Bus Speed
MEMORY SUBSYSTEM GROUP
Extended Memory Options Use BIOS Setup Utility
ON-BOARD DISK CONTROLLER
GROUP
On-board Floppy Controller Enable
On-board IDE Controller Enable Primary and
Secondary
ON-BOARD COMMUNICATIONS
DEVICE GROUP
Serial Port 1 Configuration 3F8h – IRQ4
Serial Port 2 Configuration 2F8h – IRQ3
Parallel Port Configuration 378h – IRQ7
Parallel Port Mode Extended Capabilities,
Port DMA 1
FLOPPY DRIVES GROUP
Floppy Drive A Option 3.5 1.44/1.25 MB Drive
Floppy Drive B Option Disabled or not installed
IDE DEVICES GROUP
IDE 32-Bit I/O Enable
KEYBOARD GROUP
Numlock OFF
Key Click Disable
Typematic Speed 30CPS
Typematic Delay 500 MS Delay
SCSI ROM BIOS GROUP
Embedded SCSI Devices Option
ROM
Scan
Enable