NEC MC2400 - Manual (Page 100)

4-18 Upgrading Your System
Removing DIMMs
! CAUTION
Use extreme care when removing a DIMM. Too much
pressure can damage the socket slot. Apply only enough
pressure on the plastic ejector levers to release the DIMM
1. Power off the system and remove the left side panel as described earlier in
this chapter.
2. Gently push the plastic ejector levers out and down to eject a DIMM from its
socket.
3. Hold the DIMM only by its edges, being careful not to touch its components
or gold edge connectors. Carefully lift it away from the socket, and store it
in an antistatic package.
4. Repeat the above steps to remove the remaining DIMMs.
5. Replace the side panel, plug in the system power cord, and turn on the
system.