National Instruments NI PCI-6110 - Manual (Page 116)

Index
© National Instruments Corporation I-9 NI PCI-6110/6111 User Manual
waveform generation timing
connections
overview, 4-27
UISOURCE signal, 4-30
UPDATE* signal, 4-29
WFTRIG signal, 4-28
types of signal sources
floating, 4-9
ground-referenced, 4-9
SISOURCE signal
timing connections, 4-26
timing diagram, 4-26
software drivers, D-1
software installation, 2-1
software programming choices
LabVIEW, 1-3
Measurement Studio, 1-4
National Instruments application
software, 1-3
NI-DAQ, 1-2
overview, 1-2
VI Logger, 1-4
software-programmable gain, 3-3
actual range and measurement precision
(table), 3-3
specifications
analog input
accuracy information (table), A-2
amplifier characteristics, A-3
dynamic characteristics, A-3
input characteristics, A-1
stability, A-4
transfer characteristics, A-2
analog output
dynamic characteristics, A-6
output characteristics, A-5
stability, A-6
transfer characteristics, A-5
voltage output, A-5
bus interface, A-10
CE compliance, A-12
digital I/O, A-6
electromagnetic compatibility, A-11
environmental, A-11
physical, A-10
power requirements, A-10
RTSI, A-10
safety, A-11
stability
analog input, A-4
analog output, A-6
timing I/O
frequency scaler, A-8
general-purpose up/down
counter/timers, A-7
triggers
analog trigger, A-8
digital trigger, A-9
external input for digital or analog
trigger (PFI0/TRIG1), A-9
STARTSCAN signal
See also PFI7/STARTSCAN signal
FIFO considerations, 4-24
input timing (figure), 4-22
output timing (figure), 4-23
signal routing (figure), 3-9
typical posttriggered acquisition
(figure), 4-18
typical pretriggered acquisition
(figure), 4-19
using the SISOURCE signal, 4-26
support, technical, D-1
system integration services, D-1
T
technical support, D-1
telephone technical support, D-2
timing connections
DAQ timing connections
AIGATE signal, 4-25
CONVERT* signal, 4-24