Nortech Systems Adept RS-232/TERM - Manual (Page 65)

Belt Encoder Interface on SmartController CX
Adept SmartController User’s Guide, Rev. E 65
3.9 Belt Encoder Interface on SmartController CX
For use with conveyor tracking, the SmartController CX supports two independent
external belt encoders through a 15-pin, male, D-sub connector. The pin assignments for
the Belt Encoder connector are shown in
Table 3-13 . See Figure 3-9 on page 66 for a typical
input circuit drawing.
Adept strongly recommends using differential encoder outputs for maximum noise
immunity. See the
V+ Language User’s Guide for more information on setting up and
programming a conveyor tracking application.
NOTE: Conveyor tracking requires a V + Extensions License, which can be
obtained from Adept.
Table 3-13. Belt Encoder Connector Pin Assignments
Channel 1 Channel 2
Signal Pin Signal Pin
A+ 15 A+ 11
A– 7 A– 3
B+ 14 B+ 10
B– 6 B– 2
I+ 13 I+ 9
I– 5 I– 1
Encoder 5V out 4 Encoder 5V out 4
Encoder ground 12 Encoder ground 12
not used 8 not used 8
Belt Encoder Connector Pinout
Pin 1 Pin 8
Pin 9
Pin 15