Nortech Systems Adept RS-232/TERM - Manual (Page 29)

Controller Installation
Adept SmartController User’s Guide, Rev. E 29
Not all types of CompactFlash are compatible with the SmartController. Adept requires
the use of the CF supplied by Adept at the time of controller purchase and that all
replacement CF cards be purchased from Adept.
NOTE: With an AdeptWindowsPC ethernet connection you can also use
the supplied NFS software to remotely mount hard disk drives and
directories located on a Personal Computer (PC). See the
AdeptWindows
User’s Guide for further details.
Installing CompactFlash
To install a CompactFlash (CF) into a SmartController:
1. Make sure that the SmartController is disconnected from its power source.
2. Locate the CF compartment (see Figure 2-5 ).
Figure 2-5. CompactFlash Memory Card Compartment
CAUTION: Use suitable measures for eliminating
electrostatic discharge during removal and installation of
the CompactFlash. This includes, but is not limited to, the
use of a grounded wrist strap while performing this
operation.
CAUTION: Do not remove the CompactFlash when power
is connected to the SmartController.
CompactFlash
Compartment
Eject Button