Netopia R910 User Manual

Page 95

Virtual Private Networks (VPN) 10-95

When you define a Connection Profile as using ATMP by selecting ATMP as the datalink encapsulation method,
and then select Data Link Options, the ATMP Tunnel Options screen appears.

Note: An ATMP tunnel cannot be assigned a dynamic IP address by the remote ser ver, as in a PPP connection.
When you define an ATMP tunnel profile, the Local WAN IP Address, assigned in the IP Profile Parameters
screen, must be the true IP address, not 0.0.0.0, if NAT is enabled.

Note: Profiles using ATMP do not offer a Telco Options screen.

■

ATMP Partner IP Address specifies the address of the other end of the tunnel. When unspecified, the
gateway can not initiate tunnels (i.e., act as a foreign agent) for this profile; it can only accept tunnel
requests as a home agent.

Add Connection Profile

COMMIT CANCEL

ATMP Tunnel Options

ATMP Partner IP Address: 173.167.8.134
Tunnel Via Gateway: 0.0.0.0

Network Name: sam.net
Password: ****

Data Encryption... DES
Key String:

Initiate Connections: Yes
On Demand: Yes

Idle Timeout (seconds): 300

Enter an IP address in decimal and dot form (xxx.xxx.xxx.xxx).
In this Screen you will configure the GRE/ATMP specific connection params.