Netopia R910 - Manual (Page 160)

14-160 User’s Reference Guide
Disconnect Telnet console session
If you want to close your Telnet Console session, select Disconnect Telnet Console Session and press Return.
A dialog box appears asking you to cancel or continue your selection.
If you select Continue, you will immediately terminate your session.
Factory defaults
You can reset the Netopia R910 to its factor y default settings. In the Statistics & Diagnostics screen, select
Revert to Factory Defaults and press Return. Select CONTINUE in the dialog box and press Return. The
Netopia R910 will reboot and its settings will return to the factor y defaults, deleting your configurations.
In an emergency, you can also use the Reset switch to return the router to its factor y default settings. Call
Netopia Tech Suppor t for instructions on using the Reset switch.
Note: Reset to factor y defaults with caution. You will need to reconfigure all of your settings in the router.
Transferring configuration and firmware files with TFTP
Trivial File Transfer Protocol (TFTP) is a method of transferring data over an IP network. TFTP is a client-ser ver
application, with the router as the client. To use the Netopia R910 as a TFTP client, a TFTP ser ver must be
available. Netopia, Inc. has a public access TFTP ser ver on the Internet where you can obtain the latest
firmware versions.
To use TFTP, select Trivial File Transfer Protocol (TFTP) in the Statistics & Diagnostics screen and press
Return. The Trivial File Transfer Protocol (TFTP) screen appears.
Utilities & Diagnostics
+------------------------------------------------------+
+------------------------------------------------------+
| |
| Are you sure you want to close this Console Session? |
| |
| CANCEL CONTINUE |
| |
| |
+------------------------------------------------------+
X-Modem File Transfer...
Revert to Factory Defaults...
Restart System...