Netopia R910 - Manual (Page 162)

14-162 User’s Reference Guide
press Return. You will see the following dialog box:
■ Select CANCEL to exit without downloading the file, or select CONTINUE to download the file. The system
will reset at the end of the file transfer to put the new firmware into effect. While the system resets, the
LEDs will blink on and off.
Caution!
■ Be sure the firmware update you load onto your router is the correct version for your par ticular model.
Some models do not suppor t all firmware versions. Loading an incorrect firmware version can permanently
damage the unit.
■ Do not manually power down or reset the Netopia R910 while it is automatically resetting or it could be
damaged.
■ If you choose to download the firmware, the TFTP Transfer State item will change from Idle to Reading
Firmware. The TFTP Current Transfer Bytes item will reflect the number of bytes transferred.
Downloading configuration files
The Netopia R910 can be configured by downloading a configuration file using TFTP. Once downloaded, the file
reconfigures all of the router’s parameters as if someone had manually done so through the console por t.
To download a configuration file, follow these steps:
■ Select TFTP Server Name and enter the ser ver name or IP address of the TFTP ser ver you will use. The
ser ver name or IP address is available from the site where the ser ver is located.
■ Select Config File Name and enter the name of the file you will download. The name of the file is available
from the site where the ser ver is located. You may need to enter a file path along with the file name (for
example, bigroot/config/myfile).
+-----------------------------------------------------------+
+-----------------------------------------------------------+
| |
| Are you sure you want to read the firmware now? |
| The device will reset when the transfer is complete. |
| |
| CANCEL CONTINUE |
| |
+-----------------------------------------------------------+