Panasonic PT-EW630U - Manual (Page 90)

90
- ENGLISH
Maintenance
About indicator status
If an indicator turns on
If a problem occurs within the projector, it will be notified with the temperature indicator , the filter
indicator , the shutter indicator *, and the lamp indicator .
Check the status of the indicators and take the following action.
* (Only for EZ570 series, EW630 series and EX600 series.)
CAUTION
Before you take a remedial measure, follow the procedure of switching the power off indicated in “Turning off the projector”. z
( Æ page 40)
If multiple indicators light or blink, verify the status of the projector by looking at each indicator. z
Note
Confirm the status of the power indicated on the indicator. z
When operating correctly
J
The status of the indicator is displayed with the following symbols.

: Off ,  : On ,  : Flashing , „ : Off or On or Flashing
Indicators
Status of the projector
STANDBY(R)>
Green/Red/
Orange
Red Orange
AV MUTE>
Blue
Orange
 //    
The power plug has been removed from the
outlet.
 // „ * 1 „ * 1 „ * 1 „ * 1
The projector is in the standby mode.
Turns on when pressing the
button on the remote control or the <
>
button on the side control.
 // „ * 1 „ * 1 „ * 1 „ * 1 The projector is operating normally.
 //  * 2 „ * 1 „ * 1 „ * 1 „ * 1
The lamp is cooling down. The projector does
not turn on when pressing the
button on the remote control or the <
> button
on the side control until the standby indicator
changes to red.
 * 2 // „ * 1 „ * 1 „ * 1 „ * 1
The projector is in the power management
mode. The lamp will turn on when controlling the
projector, allowing the user to start operating it.
 //  * 2 „ * 1 „ * 1 „ * 1 „ * 1
Power management mode is [On] and the lamp
is cooling down.
 // „ * 1 „ * 1  „ * 1
The shutter function has been turned on.
Press any button on the remote control or the
side control to cancel the function.
 // „ * 1 „ * 1  * 2 „ * 1
The projector is in the shutter management
mode. The lamp will turn on when controlling the
projector, allowing the user to start operating it.

/
 /  * 2 „ * 1 „ * 1  * 2 „ * 1
Shutter management mode is [On] and the lamp
is cooling down.
*1: The indicator will change according to different conditions, regardless of the status of other indicators.
*2: The indicator will flash in approximately 1-second intervals.