Panasonic PT-EW630U - Manual (Page 69)

Setting
ENGLISH -
69
Settings
Execute
J
Press ▲▼ to select one among the 1 )
items as below and then press the
button.
Start It executes the count up or count
down function.* 1
Reset Reset the P-timer values.* 2
Exit To exit the P-timer operation.
Press the button at Start and the *1 :
indication changes into Stop. To stop Count up or
Count down, press the button at Stop
on the screen menu, then the indication changes
into Restart. Press the button at
Restart to resume Count up or Count down.
Press the button at Reset to return to *2 :
the following value:
Count up "000:00"
Count down Timer that you set
Attention
To stop the [P-timer] function, press the z
button.
To cancel the [P-timer], press and hold the z
button for a few seconds.
Security
This function allows you to use the [Key lock] and [PIN
code lock] function to set the security for the projector
operation.
Press ▲▼ to select [Security]. 1 )
Press ► or the button to 2 )
access the submenu.
Key lock
J
This function locks the side control and remote control
buttons to prevent operation by unauthorized persons.
Press ▲▼ to select the desired items 1 )
as below.
Unlocked.
Lock the operation of the side
control. To unlock, use the remote
control.
Lock the operation of the remote
control. To unlock, use the side
control.
PIN code lock
J
This function prevents the projector from being
operated by unauthorized persons and provides the
following setting options for security.
Press ▲▼ to select the desired items 1 )
as below.
Off Unlocked.
On 1
Enter the PIN code every time
turning on the projector.
On 2
Enter the PIN code to operate
the projector once the power cord
is disconnected; as long as the
AC power cord is connected, the
projector can be operated without
a PIN code.
Attention
Whenever you change the PIN code lock setting or the z
PIN code (the four-digit number), you are required to
enter the PIN code. The "1234" is set as the initial PIN
code at the factory.
PIN code change
J
The PIN code can be changed to your desired four-
digit number.
Press ▲▼ to select [PIN code change] 1 )
and then press button.
Current Pin code dialog box appears. z
Press ▲▼ to enter the current code. 2 )
Press ► button to fix the number and
move the red frame pointer to the next
box.
The New PIN code input dialog box appears. z
Repeat these steps to set a new PIN 3 )
code.
Shutter
Shutter function is available to block out light to the
screen, so that the screen can be used for the other
presenters.
Press ▲▼ to select [Shutter 1 ) * ].
Press ► or the button to 2 )
access the submenu.
* (Only for EZ570 series, EW630 series and EX600
series.)
Protection
J
Prohibit the shutter operation from the remote control
and the projector's side control.