Patton electronic SmartNode 4830 Series - Manual (Page 44)

Introduction 44
SmartNode 4830 Getting Started Guide 4 • Getting started with the SmartNode
Introduction
This chapter leads you through the basic steps to set up a new SmartNode and to download a configuration.
Patton SmartNodes can be used for a wide variety of IP-based network applications. To support and ease the
configuration of the SmartNodes configuration, templates for the most important applications are available on
the Patton server at www.patton.com/voip.
The main steps for setting up a new SmartNode are shown in figure 23 .
Figure 23. Steps for setting up a new SmartNode
Console
VoIP Gateway Router
ToIP Integrated
Access Device
SmartNode 4524
Link 100M Activity
0/0 0/1 0/2 0/3
Enet 0
Vo ice P ort s
P ower Run V oIP Link
Link 100M Activity
Enet 1
1
Configure IP address
2
Connect the SmartNode to the network
3
Load configuration
Console port
Serial
interface
PC or workstation
with VT-100
emulation terminal
Ethernet interface
ETH0
Network
interface
PC or workstation
or VT-100 emulation
terminal Network
2. Modify configuration
Network
Internet
3. Load configuration
1. Download configuration example
Patton Web server
with configuration examples
Console
VoIP Gateway Router
ToIP Integrated
Access Device
SmartNode 4524
Link 100M Activity
0/0 0/1 0/2 0/3
Enet 0
Vo ice P ort s
P ower Run
V oIP Link
Link 100M Activity
Enet 1
Console
VoIP Gateway Router
ToIP Integrated
Access Device
SmartNode 4524
Link 100M Activity
0/0 0/1 0/2 0/3
Enet 0
Vo ice P ort s
P ower Run
V oIP Link
Link 100M Activity
Enet 1
Note You can manually configure the
SmartNode. You do not have to load a
configuration file.