Paradyne Hotwire 6342 - Manual (Page 121)

6371-A2-GB20-20 May 2001 IN-1
Index
Symbols
?, for determining commands available, 2-4
Numerics
802.3, Ethernet frame format, A-5
A
access control, 2-1
Address Resolution Protocol (ARP), 3-5
show timeout, A-18
Administrator access, 2-2
alarm
show command, 6-1, A-18
ARP, 3-5
show command, A-18
table, A-9
autologout, 2-6
B
basic
NAT
configuring, A-11
deleting static mapping, A-13
for DHCP server, 4-12
network configuration, 4-4
show NAT command, A-21
network configuration, 4-2
bridge
clearing statistics, A-17
commands, A-8
mode, 3-2
show command, A-19
statistics, 5-3, A-24
reasons for discarded frames, 5-7
C
clearing statistics, 5-3
command, A-17
Command Line Interface (CLI)
access, 2-3
capability, A-1
command recall, A-2
conventions used in command syntax, A-2
navigating, A-1
shortcuts, B-3
commands
bridge, A-8
DHCP relay agent, A-15
IP packet processing, A-16
show, A-18
commands available
for access level, 2-4
configuration
basic
bridging, 4-2
NAT, 4-4
routing, 4-3
DHCP
Relay with Proxy ARP, 4-11
server with basic NAT, 4-12
downstream router, 4-13
dynamic host protocol (DHCP), A-14
factory default settings, B-1
hub, 3-2
NAPT, 4-6
overview, 3-1
unnumbered DSL interface with Proxy ARP, 4-10
configure
terminal, 2-3
console
access, 2-2
show command, A-19
conventions used in command syntax, A-2
core
network, 3-12
router, 3-3
create
destination ip route, A-7
upstream eth1 IP route, A-7
customer
system identity, 2-3
D
data rates for DSL routers, 1-3
default gateway, 4-10–4-11
delete
destination IP route, A-7
upstream eth1 IP route, A-7
device restart, 6-1