Paradyne Hotwire 6342 - Manual (Page 38)

4. DSL Router Configuration Examples
4-2 May 2001 6371-A2-GB20-20
NOTES:
— Configuration examples included in this chapter cover some common
configurations, providing only a few of the possible scenarios.
— IP addresses used in the examples are for illustrative purposes only; they
are not intended to be used when configuring your local network.
— Adding static routes to the core router is typically necessary when routing
is enabled.
— Bridging-only mode is the default configuration.
Basic Bridging Configuration Example
This is the factory default configuration. To return the DSL router to the factory
default configuration, use the following command:
configure factory .
NOTES:
— When the DSL router is configured for bridging, DSL link encapsulation for
the DSL port must be configured for EtherHDLC at the line card.
— This configuration is only supported with firmware version 4.2.5 or higher.
01-16966
Customer Premises (CP)
DSL
Router
Hub
155.1.3.2
155.1.3.3
155.1.3.4
IP, IPX,
Apple Talk, etc.,
End-user
Systems
Console
Port
Connection
Ethernet DSL
Core
Router
WAN
155.1.3.1
155.1.3.5