Paradyne Hotwire 6342 - Manual (Page 75)

A. Command Line Interface
6371-A2-GB20-20 May 2001 A-9
ARP Commands
arp timeout incomplete [ time ]
Minimum Access Level: Administrator
Command Mode: Config
Specifies the Address Resolution Protocol (ARP) Table timeout value, in seconds, for
incomplete ARP table entries. The default is 5 seconds.
arp timeout complete [ time ]
Minimum Access Level: Administrator
Command Mode: Config
Specifies the ARP table timeout value in minutes for complete ARP Table entries.
The default is 20 minutes.
arp create ip-address mac-address
arp delete ip-address
Minimum Access Level: Administrator
Command Mode: Config
Creates or deletes a single, static Address Resolution Protocol (ARP) Table entry. Static
ARP entries created with this command are retained across resets/power cycles.
Examples: arp create 132.53.4.2 00:10:4b:97:6c:44
arp delete 132.53.4.2
create – Create an ARP table entry. A maximum of 64 entries can be created.
delete – Delete an ARP table entry.
ip-address – The IP address of the ARP entry to be created or deleted.
mac-address – MAC address.
arp purge
Minimum Access Level: Administrator
Command Mode: Config
Deletes ALL static and dynamic ARP Table entries.